Bearings have the right to wear out over time, which means they might need to be replaced. The hub bearings on your 2006 Chevy Silverado deserve to be found in between the axle and the brake rotors. The complying with will take it you with the steps crucial to change the front hub and also bearing assembly on your Chevrolet Silverado. Before you gain started, make certain that you space parked top top a dry, level surface. The best surface is concrete due to the fact that you will have to jack up and secure your vehicle.

Hub and Bearing Removal

Jack up your Silverado and also place it on secure stands. take it the tire and also wheel turn off the truck. If you need to, refer to instructions on how to eliminate the wheel and also tire. You must remove the former brake rotor. If necessary, refer to front brake rotor instead of instructions.

*

take the wheel rate sensor off and also remove the mounting bracket bolt because that the brake hose. Friend will find the clip on the steering knuckle. Take the wheel drive pillar nut retaining sheathe off. When you replace the wheel journey shaft, you must replace the nut by securing it through a new one. You can not reuse the old drive obelisk nut.

*

Take off the washer and the retaining nut the holds the wheel drive shaft assembly come the wheel drive shaft.

*

use axle device remover J-45859 or an tantamount tool come disengage the wheel drive column on the wheel hub and bearing.

*

as soon as you eliminate the wheel hub, you likewise need to remove the 15-series bearing bolts. Use caution when removing parts from the wheel drive shaft as seals, boots and clamps deserve to be damaged by sharp objects, and also that have the right to lead come lubricant leaks, noise and even fail of the shaft.

*

usage shop towels come wrap up the outer and inner wheel drive obelisk boots. take it mounting bolts off the wheel hub and also bearing. The mounting bolts are 25/35. take it the wheel hub and also bearing turn off the vehicle. Eliminate the splash shield. on the steering knuckle bore, remove the O-ring seal. It is a 25/35 series. Take turn off the mounting bolt to the wheel rate sensor. check the O-ring seal because that damage and also clean it. The seal will must be replaced if the is dry or brittle, has actually nicks and also cuts or has actually been compression set.

Hub and also Bearing Installation

carefully clean any kind of contaminants or corrosion from the hub and also bearing assembly and also the steering knuckle bore. use a grease because that wheel bearings to lubricate the steering knuckle bore. ar the O-ring back on the steering knuckle.

*

making use of the mounting bolt the goes to the wheel rate sensor, download it ~ above the wheel hub and bearing. You have to tighten that bolt to 13 pound per foot. using 25/35 bolts, put the wheel hub and also bearing earlier on the vehicle. Download the splash shield.

*

usage 15 series mounting bolts to install the wheel hub and bearing. usage 25/35 collection mounting bolts to install the wheel hub and also bearing. Tighten the wheel hub to the knuckle bolts making use of 133 pounds per foot. with the nut and also washer, install the wheel drive obelisk assembly top top the wheel hub and also bearing. Tighten come 177 pounds every foot.

*

replace the wheel speed sensor. Connect the brake water tap mounting bracket bolt upon the steering knuckle. Tighten to 106 pounds every inch.

*

change the rotor. replace the wheel and tire.


You are watching: How to replace front hub assembly chevy silverado


See more: How Many Rings Does Kyrie Irving Have ? Who'S Better Kyrie Or Curry

remove the auto from the jacks.

With these instructions, girlfriend will have the ability to replace your 2006 Chevrolet Silverado’s former wheel bearing assembly.